Installation; General; Fire Hazard - Hatco FWM Série Manuel D'installation Et D'utilisation

INSTALLATION

General

Hatco Waffle Makers are shipped with most components
installed and ready for use. Care should be taken when
unpacking the shipping carton to avoid damage to the unit. The
following installation/assembly procedure must be performed
before connecting electricity and operating the unit.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).

FIRE HAZARD:

• Locate unit a minimum of 2" (51 mm) from combustible
walls and materials. If safe distances are not maintained,
discoloration or combustion could occur.
• Do not obstruct air ventilation openings on outer
housing of unit. Unit combustion or malfunction may
occur.
1. Inspect the shipping carton for obvious signs of transit
damage. If damaged, inform the freight company
immediately. CAUTION! Stop! Do not attempt to use
unit if damaged. Contact Hatco for assistance.
2. Remove the unit and any loose components/accessories
from the shipping carton. The following loose components
are included in every Waffle Maker
• Two Handles
• Waffle Fork
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
3. Remove tape and protective packaging from all surfaces
of the unit.
• Make sure to remove all protective film from the stainless
steel surfaces, if present.
4. Inspect the unit for freight damage such as dents in
housing or broken handles. If damaged, inform the freight
company immediately. CAUTION! Stop! Do not attempt
to use unit if damaged. Contact Hatco for
5. Install the included handles. For each handle:
a. Move both lock nuts on the handle shaft all the way
toward the handle grip to fully expose the threads on
the handle shaft.
b. Screw the handle shaft into the threaded hole in the
cooking plate until it is tight.
c. Using a wrench, tighten the first lock nut on the handle
shaft against the cooking plate.
d. Using a wrench, tighten the second lock nut on the
handle shaft against the first nut to lock it into place.
Threaded Hole
Lock Nuts
Handle
Shaft
Locate unit at proper counter height in an area that is
convenient for use. Location should be level and strong
enough to support weight of unit and contents.
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures and grease could cause damage to unit.
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under
the Hatco warranty. Contact manufacturer of countertop
material for application information.
6. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F
(21°C). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods
assistance.
and air conditioning ducts).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
6
English
Cooking Plate
Handle Grip
Installing the Handles
CAUTION
NOTICE
Form No. FWMM-0121