Unpacking The Device; Location Of Controls; Power Sources - LEXIBOOK BT350 Série Mode D'emploi

BT350seriesIM1035_9Jan_V10.indb 7

UNPACKING THE DEVICE

When unpacking, ensure that the following elements are included:
1 x Portable Bluetooth ® speaker / 1 x USB cable /
1 x 3.5mm audio cable
WARNING: All packaging materials, such as tape, plastic sheets, wire ties
and tags are not part of this product and should be discarded.

LOCATION OF CONTROLS

1. LED and microphone
2. Speaker
3. On/Off; Call button
4. Micro USB port
5. 3.5mm audio in jack
6. Battery compartment (at the bottom of the unit)

POWER SOURCES

The portable Bluetooth ® speaker operates with a DC 5V
(included) or 3 x AA/LR6 1.5V
Via USB port
1. Connect the USB cable to a USB port.
2. Connect the other end (micro USB side) to the speaker.
Note: the USB cable does not recharge the speaker.
Battery installation
1. Open the speaker battery compartment.
2. Insert 3 x 1.5V AA/LR6 type batteries (not
included) observing the polarity markings inside
the battery compartment.
3. Close the battery compartment.
Non-rechargeable batteries are not to be recharged. Rechargeable
batteries are to be removed from the product before being charged.
Rechargeable batteries are only to be charged under adult supervision.
Different types of batteries or new and used batteries are not to be mixed.
Only batteries of the same or equivalent type as recommended are to
be used. Batteries are to be inserted with the correct polarity. Exhausted
batteries are to be removed from the product. The supply terminals are not
to be short circuited. Do not throw batteries into a fire. Remove the batteries
if you are not going to use the unit for a long period of time.
WARNING: Malfunction or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur,
unplug the USB cable or remove the batteries and insert them again.
TURNING THE DEVICE ON AND OFF
1. To turn the Bluetooth ® speaker on, press and hold the on/off button (3) until
the LED flashes red and blue. The speaker makes beep sounds and then
starts pairing.
2. Press the on/off button for 3 seconds to power off.
Notes:
- The speaker powers off automatically if no pairing occurs within 10 minutes.
- The speaker powers off automatically when battery level is too low.
type batteries (not included).
1.5V AA OR LR6
1.5V AA OR LR6
1.5V AA OR LR6
7
in USB cable
09/01/2015 12:14 PM