Nikken PIMAG ULTRA SHOWER SYSTEM Guide D'utilisation page 5

PERFORMANCE DATA:
PiMag Ultra Shower System
Rated service flow
9.5 liters / 2.5 gallons per minute
Rated service life at 90% chlorine
22,700 liters / 6,000 gallons
Maximum working pressure
860 kilopascals / 100 pounds per square inch
Maximum operating temperature
490Celsius
Notes:
• While testing was performed under standard laboratory
conditions, actual performance may vary.
• This system is not intended to be used as a drinking water
treatment unit.
• Both the system and installation
applicable state and local regulations.
This PiMag Ultra Shower System has beentested according to NSF/ANSI 177for
NSF
reduction of free
water entering the system was reduced to a concentration less than or equal to
the permissible imit for water leavingthe system, as specified in NSF/ANSI 177.
This system has not been evaluated for free available chlorine reduction performance in the
presence of chloramines. Free available chlorine reduction performance may be impacted by
the presence of chloramines in the water supply. Please contact your local water utility to
determine if chloramines are used in treating your water.
Notes on NSF Test Protocol:
Minimum chlorine reduction per NSF/ANSI177shall be listed as
(FAC)when usedwith an influent challenge water of 2 mg/L FAC
Average concentrations shall be the arithmetic mean of all reported influent challenge or
product water concentrations (the detection limit value shall be used for any nondetectable
concentration). The specified averagepercent reduction shall not be greater than the reduction
calculated using the arithmetic means of the influent challenge and the product water
concentrations respectively.
WASHER
SHOWERHEAD
removal
/ 1200 Fahrenheit
must comply with
available chlorine. The concentration
FILTER HOUSING
REPLACEABLE FILTER
CARTRIDGE
GASKET
of free available chlorine
50% free available chlorine
in