Filter Replacement - Nikken Pimag Ultra Shower System Guide D'utilisation

6. Run the shower on HOT for at least two minutes,
then cool to desired temperature. Repeat this
step each time the filter cartridge is replaced.

FILTER REPLACEMENT

Replace the filter cartridge once every six months,
or more often depending on condition of water
1. Grasp the shower unit and with other hand,
unscrew and
2. Remove the filter cartridge by twisting and pulling.
Note that the bottom end of the filter cartridge
includes an additional rubber seal (O-ring).
3. Discard the old
the shower unit, with the bottom
correct position.
4. Replace the filter dome and tighten, while firmly
grasping the shower unit. Run shower and check
for leaks. Repeat assembly procedure if necessary.
5. Run the shower
before the first
For reordering the filter cartridge: Item #13831
remove the filter
filter. Insert the
on HOT for at least
use.
3
dome.
new filter in
end in the
two minutes