Nikken PIMAG ULTRA SHOWER SYSTEM Guide D'utilisation page 3

You'll notice the difference every time you shower.
Softer-feeling hair, smoother skin, and fresher, cleaner
water are the results. Enjoy the PiMag Ultra Shower
System experience.
INSTALLATION
NOTE: Do not combine this unit with any other filter
system (including any other PiMag Shower System)
Connect the top fitting directly to plumbing pipe.
1. Make sure that your shower is completely
turned off.
2. Remove any showerhead or showerhead/filter
that is currently mounted on your fixture. When
removing it, hold the pipe it is attached to firmly,
to prevent the pipe from turning inside the wall.
Use a wrench
the pipe.
3. Remove the plastic wrap from the PiMagTM Ultra
Shower System.
4. Line up the screw threads in the inlet of the PiMag
Ultra Shower System unit with the threads on the
pipe. Turn to tighten, taking care to ensure that the
unit is properly aligned.
5. Run the shower
necessary, remove and reinstall. If unit
continues to leak, remove it and wrap Teflon or
plumber's tape around the pipe threads. Wrap
tape in the same direction as used for
tightening threads. Reinstall unit.
or other tool to unscrew
and check for
2
it from
leaks. If