Matco Tools MWLTL Mode D'emploi

MATCO
TOO'S
TWIN LIGHT
WITH INDUCTION
PLEASE READ CAREFULLY
BEFORE INITIAL USE
CHARGING INSTRUCTIONS:
Lift rubber cover on back of the charging dock, insert 5.5mm plug into jack on charging dock, and insert wa
adapter into AC power source
2 To charge both modules: Place bottom light module onto charging dock with recessed charging contacts facing
down Place top light module onto the bottom light module with flashlight facing up
To charge individual modules: Place either light module onto charging dock with recessed charging contacts
3
facing down
4 Charge indicator light on side of light module will turn RED when charging
GREEN when ful y charged
Note: Modules should only be attached using magnetic force of built-in magnets
OPERATING INSTRUCTIONS:
Depress and release button to turn light on and toggle through lighting modes
Top light module flashlight button modes: High/Low/Off
2
Top light module work light button modes: White LED High/White LED Low/Red LED On/Red LED Flasher/Off
3
Bottom light module top button for White LED: High/Low/Off
4
Bottom light module bottom button for UV LED: On/Off
5
Depress button and hold for 3 seconds in any mode to turn off light
6
Qi inductive charging compatible devices can be placed on induction charging pad to recharge
7
nsert USB plug into front USB ports to charge/power USB devices
8
Built-in magnets on base and sides of the hexagonal top and bottom module can be used to mount light modules to
9
magnetic surfaces.
10 Carabineer belt clip can be used by pushing the clip over the narrow body portion of the light module and sliding
the clip up until secure
REPLACEMENT COMPONENTS
FSMWLTL-I Top light module
FSMWLTL-2 Bottom light module
FSMWLTL-3 Carabineer
GENERAL GUIDELINES AND WARNINGS:
• Improper handling of the device may result in fire, personal injury, or property damage.
• Never charge device unattended. Do not charge on or near flammable material. Only charge
using included wall adapter.
• Modules should only be attached using magnetic force of built-in magnets.
• If device begins to balloon, swell, or smoke, discontinue using or charging immediately and observe
device in a safe place.
• Do not short-circuit, crush, incinerate, or disassemble the device.
• Do not use if device or charging cable are damaged.
• Do not dispose of batteries in trash. Always recycle batteries according to national or local regulations.
• The integrated battery should not be exposed to excessive heat such as sunshine, fire, etc.
• Foroptimal battery life, device should be operatedand stored between400F- 800F
A WARNIN G: Cancer andReproductive
The TWn Light Work Light is backed by a 1 Year Warranty This warranty covers manufacturer defects and workmanship
excludes misuse or abuse and normal wear and tear Exclusion is not allowed in some states and may not apply. This warranty gives
you specific egal rights, and you may have other rights, which vary from state to state
This device complies with Part 15of the FCC Rules.Operation
is subject to the following two conditions:(1)this device may
not cause harmful interference, and (2)this device must accept
any interference received, includinginterferencethat maycause
FCC 'D: 2AWllMWLTL
undesired operation
WORK
& FOLLOW DIRECTIONS
- CHARGE FULLY BEFORE
/ ACCESSORIES:
FSMWLTL-4 Charging dock with induction charging pad (dock only)
FSMWLTL 5 - AC wall charger adapter (3.5A)
belt hook
Harm. www P65Warnings.ca.gov
LIGHT
CHARGING
BEFORE USE
USE (4-8 HOURS)
PAD
Charge •ndicator ight will turn
Matco Tools I Stow, Ohio 44224
www.matcotools.com
MWLTL
The warranty
2005069-08