ProPlus 367804 Instructions D'opération page 7

Take down the installation
1) Drain the windbreak by turning the drain valves (fig 5) To deflate the windshield, the middle ring must be
loosened (fig. 1, part B)
2) Remove all pegs and oosen all guy lines
3) Fold and roll towards the opened valves. This leaves the remaining air out
4) Roll up the windbreak, place in the carrying bag and zip it closed
MAINTENANCE
• Fully vent the windbreak and make sure it is completely dry before it is packed
• Store in a well-ventilated dry place
• Do not wrap the windshield wet / damp to prevent mold Clean with water and a soft brush DO not use
cleaning agents and do not scrub hard
• The windbreak requires no maintenance but must be protected against damage during storage.
• Damage as a result of improper use, wind damage or neglect is not covered by the warranty
• Have any damage repaired at the first opportunity
7