ProPlus 367804 Instructions D'opération page 6

i
INDEX
SAFETY INSTRUCTIONS
USAGE
MAINTENANCE
SAFETY INSTRUCTIONS
• Read the instruction manual carefully before use and keep it for future reference
• Make a test setup first before the product is used in practice
• Check the windbreak for signs of damage before use
• Ensure that the hose connection is not impeded (by a kink)
• The windbreak is intended for use in light to moderate weather. In case Of strong wind, we recommend
breaking off the windshield (setup) or not setting it up
• Long-term use in strong sunlight is not recommended;
environment.
• UV damage is not covered by the warranty; damage caused by sunlight is at your own risk.
USAGE
1) Locate the inflation valve / inflation valves and ensure that they are fully tightened before air is pumped
into the windshield (fig 1, part A and B) The cap (fig 1, part C) must be loosened for inflation. To deflate
the windshield, the middle ring must be loosened (fig 1, part B)
2) Inflate the windbreak, with the supplied pump, at the inflation valve(s)
For art.nr. 367804 a pump is not included. With item no. 367806 and 367808 the pump is protected
against overload by means of a pressure relief valve. If this pump is not used, the recommended
pressure is 7 psi (0.48 bar)
3) Guide the windbreak so that it is in the correct position (fig. 2).
4) Secure the windbreak with pegs and guy lines and start with the comers (fig 3)
5) Clamp the external guy lines (fig. 4) to the windbreak and ensure the position of the windbreak
A B
INDEX
c
6
if possib e, set up the windbreak (in part) in a shady
6
6
6
7
inflation