Assembly; Filling The Tank - Domair BREEZE Manuel D'utilisation

ASSEMBLY

1 Attach the 4 castors to the base 12.
2 Fit the motor block tube 8 to the main
body and secure it with the supplied
screw.
3 Unscrew the locking nut 13 on the
main body 11, place the main body on
the base and secure it with the locking
nut.
4 Ensure that the stand is entirely stable
before continuing.
5 Install the rear grille on the motor axle
while respecting the adjustment of
notches and centring pins. Screw in
the locking nut (6) of the grille. Insert
the propeller on the axle and screw on
the locking nut (2) of the propeller.
6 Attach the front grille 3 to the rear grille
carefully following the instructions be-
low:

FILLING THE TANK

Rev 0-02 12 19
- Fasten the front grille to the rear grille
using the plastic hoop provided. For
this, it is necessary to snap on the clips
found on the inside of the hoop around
the edges of the grilles.
- Press the hoop firmly to the grilles until
all the clips are correctly snapped on.
- Secure the assembly by firmly screwing
in the safety screw to the hoop.
IMPORTANT: After assembly, never
disassemble the grilles during use or
maintenance.
7 Install the mist diffuser 2 on the front
grille, then connect the flexible tube to
the mist diffuser.
Fabriqué en Chine Page 29