Abicor Binzel MF1-Rear Mode D'emploi page 21

MF1 rear
1 Identification
The MF1 rear is part of the MFS-V3 wire feeder system and is used in industry and the trade for the delivery
of welding wire or solder. The MF1 rear is a 4-roll wire drive that is solely used as the rear drive for feeding
the wire in push-push mode. All other media (coolant, shielding gas, welding current) required for the joining
process must be separately supplied.
These operating instructions only describe the MF1 rear master feeder. The MF1 rear must only be operated
using original ABICOR BINZEL spare parts.
1.1 CE marking
This device fulfils the requirements of the relevant EU directives.
Conformity is confirmed by the CE marking on the device.
1 Identification
EN - 3