Operation Instructions; Torque Settings - erba 33678 Mode D'emploi

GB - INSTRUCTION MANUAL

8. OPERATION INSTRUCTIONS

Charging the battery pack (6)
Remove the battery pack from the drill and plug it into the charger (8).
Connect the charger to the power supply
The red light indicates the charging process.
The green light indicates the end of the charging process.
To prolong the lifespan of the battery pack avoid discharging it completely. Check the indicator
light (10) on the cordless drill.

Torque settings

You can set the torque of the cordless drill by using the torque dial (2).
Lower settings indicate lower torque, higher settings will increase the torque.
There are 19 torque settings for tightening screws, and one torque setting (indicated by a drill
symbol) for drilling.
If the given application exceeds the chosen torque setting, the chuck will stop rotating and the
cordless drill will create a ratcheting sound. Note that this will not happen when the drill setting
is selected!
Chose the torque setting according to the screw size and material. Bigger screws and harder
materials will require higher torque settings.
You can select the direction of the drill by pushing the left/right direction switch (4).
Pushing the power button will start the drill.
The max. rpm depends on the selected gear (see technical data) using the gear selector switch (3)
To change the bits, open the chuck and put the required bit into the opening, then tighten the
chuck again.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 12
Changes, print, punctuation and other errors reserved!
Instruction manual
33678
Issue: 07/2017