Important Information For Initial Operation; Operation Instructions; Lock Button - erba 33651 Mode D'emploi

GB - INSTRUCTION MANUAL

7. IMPORTANT INFORMATION FOR INITIAL OPERATION

Before first use
The power source must match the technical details as indicated in this manual and on the type
sticker of the product. . 230V machines can also be used with a 220V power source.
Recommended usage duration: max. 20 minutes continously
Cooldown: 5-10 minutes
Caution:
Never switch the left/right toggle when the machine is running!

8. OPERATION INSTRUCTIONS

Quickchange chuck
Disconnect from the powersource.
Hold the back of the chuck with one hand, and turn the front end to the right to open the chuck.
Put the drillbit into the chuck all the way to the bottom of the chuck.
Close the chuck firmly by turning it to the left.
Make sure the drill (or any other suitable tool) is secured tightly and correctly.
Changing the chuck
Open the chuck completely and unscrew the screw on the inside of the chuck.

Lock button

For continuous operatrion push the powerswitch and the lock button at the same time. To unlock the
powerswitch, press it and it should unlock. Always unlock the powerswitch when you are not ope-
rating the machine to avoid injury. When plugging in the machine, make sure that the powerswitch
is unlocked!
Left/right toggle
Use the left-right toggle to change the direction of the drill's rotation. The machine must be at a full
stop before changing the drill's rotation.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 13
Changes, print, punctuation and other errors reserved!
Instruction manual
33651
Issue: 12/2016