Speed Dial; Carbon Brushes - erba 33651 Mode D'emploi

GB - INSTRUCTION MANUAL

Speed dial

The speed of the drill can be adusted using the sped dial. Higher numbers indicate greater speed.:
use lower speeds to start drilling materials, that have not been center-punched, for tightening/
loosening screws or for drilling delicate materials
Use medium speeds for drilling metal and plastic
Use high speeds for wood, stone and soft metal
Drilling / Impact drilling
For drilling metal, wood or plastic and for tightening/loosening screws use the drill function as
indicated by the „drill" symbol. For impact drilling (stone, concrete, etc.) switch to the „hammer"
symbol.

Carbon brushes

Worn down carbon brushes need to be replaced by a qualified service technician.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 14
Changes, print, punctuation and other errors reserved!
Instruction manual
33651
Issue: 12/2016