Hope EVO/RX Instructions

CAUTION: READ
b t.....:.... WORKING ON YOUR
Riding bicycles can be dangerous.
read thoroughly before ang maintenance.
instructions before using Hope Technology
result in severe injury or death
REMOVE DRIVE SIDE
CAPTIVE EXTRACTION
001 _Start with the crankset
002 _Using HC108-13T tool,
nut spline.
NOTE: Captive nut has LH thread.
003_Using 19mm open end spanner
to loosen.
REPLACE DRIVE
CAPTIVE EXTRACTION
004_Grease the inside face of the
005_AppIg a small amount
to the threads. Loctite 222/243
006_Thread the captive nut back
initially to ensure it is not cross
with 19mm spanner.
REMOVE NON-DRIVE
(HC106 07)
007 _Using HC108—13T tool,
008_Using 19mrn socket turn
to loosen
REPLACE NON-DRIVE
009_Grease the threads of the
010_Thread the end cap back into the
initially to ensure it is not cross
011 _Tighten end cap using torque
socket on tool to 50Nm.
EVO/RX CRANKS
END CAP REMOVAL
THIS BEFORE
CRANKS
These instructions should be
Failure to follow these
components can
NUT (HC106-04)
fitted to the bike.
insert tool end A into captive
turn nut CLOCKWISE
SIDE
NUT
nut as shown
of thread locking compound
or similar.
into the crank arm, bg hand
threaded. Using tool, tighten
SIDE END CAP
insert end B into end cap spline.
the cap ANTI-CLOCKWISE
SIDE END CAP
end cap as shown
axle thread, bg hand
threaded
wrench and 19mm
TOOLS REQUIRED
EVO Crankset End cap Tool:
19mm Open end spanner
Torque Wrench with 19mm
001
HClØ
-13T
TOOL END A
004
GREASE
THIS FACE
007
TOOL END B
oog
GREASE THREAD
HC108-13T
socket
003
LOOSEN CLOCKWISE
006
TIGHTEN
ANTI-CLOCKWISE
008
LOOSEN
ANTI-CLOCKWISE
011
TIGHTEN CLOCKWISE
HOPETECH.COM
50