Lorell LLR84178 Instructions

b•4Q
INSTRUCTIONS
1. Assemble posts by taking one short post with threaded
another short post without
the bottom of the post. Repeat this step until you have 4 tall posts assembled.
2. Snap shelf supports
desired height for the bottom shelf only. Be sure the wider, flared edge of the plastic support
down position toward the floor. The small lip located inside the plastic shelf support
grooves located at 1" intervals
3. Stand one shelf on its side and insert the posts with the plastic shelf supports
shelf post holes located at each corner of the shelf until the support
support is snapped
place by tightening
4. Stand the unit upright. Firmly push the bottom shelf onto the shelf supports to stabilize the unit.
5. Add additional shelves by positioning
described in step B, starting
location, carefully
each corner of the shelf. Work your way up from the bottom to the topmost
Wire Shelving Units/Unités d'étag&res g rillagées/Repisas M etålicas
stud. The narrow threaded
onto posts by placing two plastic shelf support
on each post. Repeat this step for each post.
together with the wider faired edge down toward the floor, the shelf will lock into
itself around the support.
plastic shelf supports
from the bottom
lower a shelf from the top by inserting
LLR84178/84181/84184/84187/70060/70061/69140/69145
4 PCS/MCX/PZAS
4 PCS/MCX/PZAS
8
stud and inserting
hole is where the rubber feet will be inserted at
at desired heights
up. As you position
the four posts into the four holes located at
32 PCS/MCX/PZAS
4 PCS/MCX/PZAS
b'4_q
into wide threaded
halves around the posts at the
must snap into the
in place up through
meets the shelf. If the plastic shelf
in the same manner as
the shelf supports for each shelf
shelf.
hole of
is in the
the