Amana ACR2303MF Guide De Dimensions

PRODUCT MODEL NUMBERS
ACR2303MF AER3311WA
ACR3130BA AER5330BA
ACR4303ME AER5523XA
ACR4303MF AER5524XA
ACR4503SF
ACR4530BA
ACR4503SF
Electrical: To properly install your range, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
■ Range must be connected to the proper electrical voltage and
frequency as specified on the model/serial number rating plate. The
model/serial number rating plate is located on the left-side frame
behind the storage drawer panel or behind the top right side of the
oven door. Refer to the figures in the "Product Dimensions" section of
the "Location Requirements" section.
■ This range is manufactured with the neutral terminal connected to
the cabinet. Use a 3-wire, UL Listed, 40- or 50-amp power supply cord
(pigtail) (see following Range Rating chart). If local codes do not permit
a ground through the neutral, use a 4-wire power supply cord rated at
250 volts, 40 or 50 amps and investigated for use with ranges.
Range Rating*
120/240 Volts 120/208 Volts
8.8 – 16.5 KW 7.8 – 12.5 KW
16.6 – 22.5 KW 12.6 – 18.5 KW
* The NEC calculated load is less than the total connected load listed on
the model/serial rating plate.
** If connecting to a 50-amp circuit, use a 50-amp rated cord with a kit.
For 50-amp rated cord kits, use kits that specify use with a nominal
13/8" (34.9 mm) diameter connection opening.
■ A circuit breaker is recommended.
CABINET OPENING DIMENSIONS
Cabinet opening dimensions shown are for 25" (64.0 cm) countertop
depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop
height.
IMPORTANT: If installing a range hood or microwave hood combination
above the range, following the range hood or microwave hood
combination instructions for dimensional clearances above the cooktop
surface.
A freestanding range may be installed next to combustible walls with
zero clearance.
* NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet
is covered by not less than 1/4" (0.64 cm) flame-retardant millboard
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
W11784647B
30" (76.2 cm) Freestanding Electric Range
AER5630BA
AER5823XA
AER5830VA
AER6303MF
AER6603SF
AER6203MSS
YAER6203MSS
Specified Rating of
Power Supply Cord Kit
and Circuit Protection
Amps
40 or 50 **
50
PRODUCT DIMENSIONS
A
F
E
A. 273/4" (70.5 cm) max. depth with handle
B. 467/8" (119.1 cm) overall height (maximum) with leveling legs
screwed all the way in*
C. 36" (91.4 cm) cooktop height (maximum) with leveling legs screwed all
the way in*
D. 297/8" (75.9 cm) width
E. 255/16" (64.3 cm) depth – back of range to front of cooktop**
F. Model/serial rating plate (located on the left-side frame behind
storage drawer or right side of frame behind the oven door)
IMPORTANT: Range must be level after installation. Follow the
instructions in the "Level Range" section. Using the cooktop as a
reference for leveling the range is not recommended.
* Range can be raised approximately 1" (2.5 cm) by adjusting the
leveling legs.
** Front of door and drawer may extend further forward depending on
styling.
A
C
B
D
E
F
B
C
D
A. 13" (33.0 cm) maximum
upper cabinet depth
B. 30" (76.2 cm) minimum
opening width
C. For minimum clearance to
top of cooktop, see NOTE*
D. 301/8" (76.5 cm) min
opening width
E. Outlet – 8" (20.3 cm)
to 22" (55.9 cm) from either
cabinet, 51/2" (14.0 cm)
max. to floor
F. Cabinet door or hinges
should not extend into the
cutout