USRobotics USR997933 Guide D'installation page 8

Wall Mounting Instructions
1. Insert the two wall screws in to the wall.
Note: Do not insert the two wall screws completely to the wall. There should be a 1.5mm to
2.0mm gap between the wall and the head of the screws. If the rubber feet are placed on
the switch, additional clearance may be needed.
2. Fasten the mounting clips to the switch.
3. Position the mounting clips on the switch over the wall screws and slide the switch down on
to the wall screws.
Troubleshooting
My 10/100/1000 Mbps 8-Port Switch is properly connected to my Ethernet-
ready device but my connection speed is slow.
Possible Solution:
Verify that your network adapter and/or additional Ethernet-ready device supports 1000 Mbps.
You may be using a 10/100 Mbps device. A blinking orange light indicates you are receiving and
transmitting data at 10 Mbps. A blinking green light indicates you are receiving and transmitting
data at 100 Mbps. A blinking blue light indicates you are receiving and transmitting data at 1000
Mbps. To achieve 1000 Mbps speeds, replace any 10/100 Mbps devices you are using with 1000
Mbps devices.
Possible Solution:
Verify you are using a known and reliable RJ-45 Category 5 Ethernet cable. An old or unreliable RJ-
45 Category 5 Ethernet cable could diminish your link quality. It may be necessary to replace your
RJ-45 Category 5 Ethernet cable.
Possible Solution:
The length of your Ethernet cable between your 10/100/1000 Mbps 8-Port Switch and your
workstation or computer should not exceed 328 feet.
Possible Solution:
Some power sources with strong electromagnetic fields may also be causing interference.
4