Parts Names And Functions; Remote Control; Basic Operation; Front Panel - Pioneer U-05-s Guide Rapide

Parts names and functions

Remote control

1
2
3
4
5
6
7
1  STANDBY/ON
Use to alternate power status between ON and
STANDBY modes.
2 MUTE button
During playback, press to temporarily mute the sound.
3 VOL +/− buttons
Press these buttons to raise/lower the sound volume.
4 Direct input selector buttons
Press one of the USB/COAX/OPT/AES EBU buttons to
select the desired source.
5 LOCK RANGE button
Press to adjust the DAC locking range.
6 DIRECT button
Press this button to output the input signal as is,
without passing through the DSP .
7 Hi-Bit 32 button
Press to change the Hi-Bit 32 setting.
8
8 DIMMER button
Press to adjust the display's brightness.
9 FINE +/− buttons
Use to fi nely adjust the headphone volume (this
9
adjustment affects only the headphone output).
a DIGI FILTER button
Press to change the type of digital fi lter used.
b Up Sample button
Press to change the Up Sampling setting.

Basic operation

1 Turn power ON.

Press the front-panel /I STANDBY/ON button.
• The power indicator in the center of the button will
a
light.
2 Select the desired output connector.
b Rotate the front-panel OUTPUT knob.
Set to LINE to select the analog output connector.
3 Select the desired input source.
Rotate the front-panel INPUT knob, or press the
corresponding direct input selector button on the
remote control.
• The selected input will appear in the display window.
• DSD data can be played only when using the USB
connection.
4 Operate the playback device.
For details, consult the operating instructions for your
playback device.
5 Adjust the sound volume.
Rotate the unit's front-panel VOLUME knob, or use the
VOL +/− buttons on the remote control.

Front panel

1 2 3 4
a b
1 /I STANDBY/ON
Use to alternate power status between ON and
STANDBY modes.
When the unit's power is ON, the power indicator in
the center of the button will light.
2 INPUT knob
Use to select the input source.
The selected source will appear in the display window.
3 DIRECT indicator
See "Direct setting" of the operating instructions.
4 Hi-Bit 32 indicator
See "Hi-Bit 32 setting" of the operating instructions.
5 Up Sampling indicator
See "Up Sampling setting" of the operating instructions.
6 LOCK RANGE ADJUST indicator
See "Adjust the DAC locking range" of the operating
instructions.
7 Display window
8 Remote control sensor
9 VOLUME knob
In order to control the sound volume of a component
connected to the unit's analog output connector,
Selector switch 1 (on unit's rear panel) must be set to
VARIABLE.
5 6 7 8 9
c d
a PHONES GAIN knob
Use to adjust the headphones gain.
b OUTPUT knob
Use to select the type of output, including LINE, and
PHONES 1 to PHONES 3.
c Headphones connectors (PHONES 1, 2, 3)
Use to connect headphones.
d FINE ADJUST knob
Use to fi nely adjust the headphone volume (this
adjustment affects only the headphone output).
3