Table des Matières
Publicité
ENGLISH
1) GENERAL OUTLINE
The Q.BO TOUCH is a 10-channel transmitter. Each
channel is associated with a code to be typed on the
keyboard.
The transmitter is powered by batteries, therefore
no wired electrical connection is needed. The Q.BO
TOUCH is provided with touch keys; for any operation,
it must be activated by means of the ON key. It can
manage up to 100 different CODES (each CODE con-
sists of a sequence of min. 4 and max. 7 figures) and up
to 10 different activation CHANNELS, each CHANNEL
SIGNAL INDICATIONS
Signal Heard
1 Short beep
1 Long beep
3 Short beeps
RED led fixed after the correct code is entered
RED indicator LED
Green/Yellow indicator LED
ON and function key
Key to confirm operation
Numerical keypad
2) TECHNICAL SPECIFICATIONS
Batteries
Working temperature:
No. of channels:
Frequency:
Transmission:
Range:
Degree of protection:
Dimensions
(*) The range can be affected by environmental and
installation conditions.
INSTALLATION MANUAL
2X CR123A min.1400mAH
-10 +55 °C
10
433.92 MHz
Rolling Code
100m in open field (*)
IP55
Fig. A
corresponding to a different control unit installed (e.g.
sliding gate opening with channel 1 and overhead
door opening with channel 2). The Q.BO TOUCH has a
sensor which, in case of poor light, activates keyboard
lighting to make it easier to enter the code.
For reasons of system safety, in order to add an ena-
bled code, it is necessary to enter a password (default
1234). Such password can be changed and must be
remembered by the user.
WARNING: Keep the anti-tamper Allen key provided
in the kit.
Indicates that a key has been pressed
Code entered correct/ memorisation on control unit
Code incorrect/error
Battery exhausted
3) INSTALLATION
WARNING: think carefully about the installation site.
Structures made from ferrous material could have an
adverse effect on the Q.BO TOUCH's operation.
-------------------------------------------------------------------
-------------------------------------------------------------------
4) MEMORIZING ON CONTROL UNIT/RECEIVER
(Fig.C points 1-5).
To control a number of control units separately, use a dif-
ferent channel for each, entering the default codes.
Once that is done, change the codes.
-Change 1111 to 56561
-Change 2222 to 56562
-Change 3333 to 56563
This makes it easier to remember the code as 5656 fol-
lowed by the function number (1 for sliding gate, 2 for
overhead door A, 3 for overhead door B), therefore:
-ON -> 56561 OK -> opens the sliding gate
-ON -> 56562 OK -> opens overhead door A
-ON -> 56563 OK -> opens overhead door B
5) TOTAL DELETION OF CODES (Fig.D points 1-5)
Following the total deletion of all codes, Q.BO TOUCH will
need to be memorized again on the control unit.
Meaning
(Fig.B points 1-6)
Q.BO TOUCH -
19
Publicité
Table des Matières
