Publicité
5
6
1. INPUT JACK: High-impedance input for electric guitar, bass, acoustic
guitars with pickup systems, and other instruments.
2. DC POWER CONNECTOR: Connect DC adapter here. Standard
center-negative 9VDC jack for use with appropriate power supplies.
3. OUTPUT JACK: Low-impedance output connects to amp or next
pedal in signal chain.
4. LIGHT SENSOR: Senses room brightness for auto screen dimming.
To disable auto screen dimming, press and hold footswitch while
applying power and then press the footswitch to toggle on or off.
5. DISPLAY SCREEN: Displays current reference pitch, mute status and
note being registered. Indicates if note being registered is sharp, flat or
at correct pitch.
6. BYPASS/MUTE FOOTSWITCH: Turns tuner on and off. Output signal
is muted when tuner is on, indicated by MUTE icon. BYPASS SWITCH
determines bypass type when tuner is turned off.
7. USB PORT: For powering the pedal by connecting a USB-C 5V power
supply. Port is also used for firmware updates.
8. BYPASS SWITCH: Three-position switch selects footswitch bypass
TRU: When tuner is off, pedal is bypassed using true bypass.
BUF: When tuner is off, pedal is bypassed using a high-quality buffer.
MUTE: Tuner is always on in monitor mode; pressing footswitch mutes signal for
silent tuning.
9. MODE BUTTON: Selects display mode and reference pitch frequency:
SINGLE PRESS: Toggles between strobe and needle display modes.
PRESS/HOLD: Press and hold for three seconds to unlock reference pitch for
editing; press again to toggle reference pitch to desired frequency between 430
and 450Hz. If not pressed for
from editing.
FEATURES
4
three seconds, reference pitch frequency will lock
1
2
7
3
9
8
functions:
Publicité
