Publicité
Positioning
Install the appliance on a flat hard floor.
Make sure that air circulation around the appliance is not impeded by
carpets, rugs, etc.
Allow at least 2 cm of clearance at each side of the appliance.
Make sure that the appliance does not stand onto the power cord.
Installation location requirements
Before installing the appliance, the location characterised as follows shall be
selected:
Rigid, dry, and level surface
Avoid direct sunlight
Sufficient ventilation
Room temperature is above 0°C.
Keep far away from heat resources such as coal or gas burning appliances.
The ambient temperature of the washer should be 5-40°C. If used under 0°C, the inlet valve and draining
system may be damaged. If the machine is installed under freezing conditions, it should be transferred
to normal ambient temperature to ensure the water supply hose and drain hose can unfreeze before
use.
Levelling the appliance
Levelling the washing machine properly prevents excessive noise and vibration.
Install the appliance on a solid and level floor surface.
If the floor is uneven, turn the adjustable feet as required.
Never put cartons, wooden blocks or similar materials under the feet.
Electrical connection
Your washing machine works with 220-240V and 50Hz.
Electrical connections must be carried out by a qualified technician in compliance with the local safety
regulations.
Your washing machine must be properly earthed. We will not be held responsible for any damage that
1. Loosen the lock nuts with a spanner.
2. Turn the adjustable feet to adjust the height.
Make sure that all four feet are stable and resting
on the floor and then check that the appliance is
perfectly level using a spirit level.
3. Tighten the lock nuts.
119
Publicité
