Table des Matières

Publicité

Préparation à l'installation d'un nouveau SE (CLI d'Oracle ILOM)
->
start /HOST/console
Are you sure you want to start /HOST/console (y/n)?
Serial console started. To stop, type #.
Le serveur peut prendre plusieurs minutes pour effectuer l'autotest de mise sous tension
(POST). Ensuite, l'invite OpenBoot (
Procédez à l'initialisation à partir du média correspondant à votre méthode
5.
d'installation.
Pour plus d'informations, reportez-vous à la section sur la comparaison des méthodes
d'installation dans Installation des systèmes Oracle Solaris 11 correspondant à la version de
votre choix à l'adresse :
http://www.oracle.com/goto/solaris11/docs
Pour obtenir la liste des commandes d'initialisation que vous pouvez entrer à l'invite OpenBoot,
tapez :
{0} ok
boot <specifier>
Examples:
boot
boot net
boot cdrom
boot disk1:h
boot tape
boot disk myunix -as
dload <filename>
Examples:
4000 dload /export/root/foo/test
?go
Lors de l'installation, indiquez les paramètres de configuration conformément
6.
aux instructions.
Voir
"Paramètres de configuration du SE Oracle Solaris" à la page
Informations connexes
"Configuration du SE préinstallé" à la page 74
"Préparation à l'installation d'un nouveau SE (CLI d'Oracle ILOM)" à la page 75
"Préparation à l'installation d'un nouveau SE (interface Web d'Oracle
ILOM)" à la page 77
"Pour affecter une adresse IP statique au port NET MGT" à la page 80
76
Guide d'installation du serveur SPARC T7-1 • Octobre 2015
help boot
( -- )
boot kernel ( default ) or other file
- boot kernel from default device.
- boot kernel from network
- boot kernel from CD-ROM
- boot from disk1 partition h
- boot default file from tape
- boot myunix from disk with flags "-as"
( addr -- )
- if executable program, execute it
or if Forth program, compile it
y
) s'affiche.
ok
Factory default is to boot
from DISK if present, otherwise from NET.
debug load of file over network at address
79.

Publicité

Table des Matières
loading

Table des Matières