Raider PRO RDP-BCLM20 SOLO Mode D'emploi page 21

21
Warning: When mowing, do not allow the motor to runs in heavy conditions.
When the motor run the revolutions of the motor will drop and you will hear a change in the motor
sound. When this occurs stop mowing, release the switch lever and raise the height of cut.
Failure to do so could damage the machine.
NOTE: The battery packs are protected by a safety cut–out function which is activated when the
blade becomes jammed or if the motor is overloaded. When cut-out occurs, stop mowing and
disconnect the lawn mower from the power supply. Clear any obstruction and wait for a few minutes
for the safety cut out switch to reset before continuing to use the mower. If the mower cuts out again
increase the height of cut to reduce the load on the motor.
NOTE: The temperature of the motor will rise quickly,
if the lawn mower frequently jams. If the motor overheats, the safety cut out switch will operate and
will cut off the power. If this occurs, you will need to disconnect the lawn mower from the power
supply and wait for it to cool down completely. You will need to wait for approximately 1 hour before
you can start using the mower again.
Blade Replacement
Switch off the lawnmower and disconnect from the mains supply. Before replacing the blade it is
advisable to thoroughly clean the underside of the machine.
Always wear work gloves when replacing the blade. Note which way the blade is fitted. Hold the
blade firmly with one hand and using the spanner to remove the blade securing bolt anticlockwise.
Remove the blade and thoroughly clean the area around the shaft. To attach the new blade
(400mm), align the blade onto the drive shaft ensuring that the mark on the blade is on the outside
and the two studs on the back of the fan are located into the corresponding two holes in the blade.
Tighten blade securing bolt clockwise, do not over tighten.
Check to ensure the blade is located correctly before using the lawnmower
Grass box/bag:
The lawnmower is fitted with a grass box/bag. To attach the grass box/bag, raise the flap on the
mower body, align the mounting holes on the grass box/bag with the bulges on the mower body and
press to hear a click.
To remove the grass box/bag, raise the flap on top of the grass box/bag, lift the grass box/bag
upwards to detach grass box/bag from mower body.