Publicité
irritation or burns.
• Do not use a battery pack or tool that is damaged or
modified. Damaged or modified batteries may exhibit
unpredictable behaviour resulting in fire, explosion or risk
of injury.
• Do not expose a battery pack or tool to fire or excessive
temperature. Exposure to fire or temperature above 130 °C
may cause explosion.
• Follow all charging instructions and do not charge the
battery pack or tool outside the temperature range
specified in the instructions. Charging improperly or at
temperatures outside the specified range may damage the
battery and increase the risk of fire.
BATTERY POWER TOOL SERVICE
• Never service damaged battery packs. Service of battery
packs should only be performed by the manufacturer or
authorized service providers.
SAFETY INSTRUCTIONS FOR MULTI-TOOLS
• Wear a suitable dust protection mask. The dust produced
when using this tool may be harmful to the health of the
operator or bystanders.
RESIDUAL RISKS
Even with application of safety standards and using the tool
as prescribed, certain residual risks can remain:
• Risk of personal injury due to prolonged use.
• Risk of injury caused by dust.
• Risk of injury caused by flying objects.
• Risk of burns due to accessories becoming hot.
STORAGE
• Store the device and its accessories in a dry and
dustproof location. Store it out of the reach of children.
• Store the bits separately to avoid mechanical damage
or confusion with other tools. Protect the bits from
excessive heat (e.g. by storing near heating pipes or
steam pipes) and from UV radiation.
• If you intend to store a battery for a period without use
then store battery at room temperature (0°C to 20°C)
When storing for very long periods boost charge the
battery once per year to prevent over discharge. The
Ambient temperature range for tool and battery use: 0°C
to 40°C. The charging temperature: 5°C to 40°C.
CLEANING
• The device must not be sprayed with water or placed in
water. Otherwise there is a risk of electric shock.
• Keep the device, its handle and the accessories clean. Use
a dry cloth or brush to do this. Do not use any cleaning
agents or solvents. They could damage the device
irreparably. Do not use water or metal objects.
MAINTENANCE
If a fault develops, disconnect the battery immediately and
contact Evolution Power Tools Customer Service. Do not
attempt to repair the tool.
PRODUCT OVERVIEW KEY
1. LED light
2. Locking pin
3. Auxillary handle port
4. Speed dial
5. Battery port
6. Auxillary handle
7. Tool release lever
8. On/off switch
9. Belt hook
10. Belt hook screw
11. Plunge cut blade
12. Scraper blade
13. Sanding pad
14. Sandpaper x2
NOISE WARNING
WARNING: The noise emissions during actual use of the
power tool can differ from the declared values depending
on the ways in which the tool is used especially what kind of
workpiece is processed.
ADDITIONAL BATTERY AND CHARGER
SAFETY WARNINGS
Please refer to the safety warnings and instructions provided
in the battery manual and the charger manual.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer
for recycling advice.
Publicité
