Before Returning For Repairs - Schumacher Electric INSTANT POWER IP-75 Guide D'utilisation

10.4 If the Instant Power is moved around the
shop or transported to another location,
take care to avoid/prevent damage to the
cords, clips and Instant Power. Failure
to do so could result in personal injury or
property damage.
IMPORTANT: Do not use and/or store the
Instant Power in or on any area or surface
where damage could occur if the internal
battery should unexpectedly leak acid.
10.5 IMPORTANT:
• CHARGE IMMEDIATELY AFTER
PURCHASE
• KEEP FULLY CHARGED
11. TROUBLESHOOTING
PROBLEM
The Instant Power won't jump
start my car.
The Instant Power won't
power my 12V device.
The battery in the Instant
Power won't hold a charge.

12. BEFORE RETURNING FOR REPAIRS

If these solutions do not eliminate the problem, or for more information
about troubleshooting, contact customer service for assistance:
For REPAIR OR RETURN, contact Customer Service at 1-800-621-5485.
DO NOT SHIP UNIT until you receive a RETURN MERCHANDISE AUTHORIZATION
(RMA) number from Customer Service at Schumacher Electric Corporation.
POSSIBLE CAUSE
Clamps are not making a good
connection to the battery.
Connections are reversed.
The Instant Power's battery
is not charged.
The vehicle's battery is
defective.
The 12V device is not
turned on.
The Instant Power's battery
is not charged.
The 12V device draws more
than 15A or has a short
circuit.
The battery is bad (will not
accept a charge).
services@schumacherelectric.com
www.batterychargers.com
or call 1-800-621-5485
Monday-Friday 7:00
• 7 •
• Charge the Instant Power's internal battery
immediately after purchase, after every use
and every 30 days.
• All batteries are affected by temperature.
The ideal storage temperature is at
70° F. The internal battery will gradually
self-discharge (lose power) over time,
especially in warm environments.
Leaving the battery in a discharged state
may result in permanent battery damage.
To ensure satisfactory performance and
avoid permanent damage, charge the
internal battery every month.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Disconnect the Instant Power
and reverse the clamps.
Press the Battery Status button
on the front of the unit. The
LEDs will indicate the status of
charge.
Have the battery checked.
Turn on the 12V device.
Check the battery charge
status by pressing the Battery
Status button.
Contact a qualified service
technician, to replace the fuse.
Replace the battery.
to 5:00 CST
am pm
REASON/SOLUTION