Makita DCG180 Manuel D'instruction page 8

For big holder (800ml(48.8cu.in))
D
D
Insert the rod into the slit of the tool.
Attach the piston and tighten it with a screw.
To remove the rod and piston, follow the installation
procedure in reverse.
NOTICE:
• The teeth on the rod must point down.
• There are four types of pistons. Piston A and D for
cartridges. Piston B for film type packs. Piston C
for direct filling.
• Choose appropriate piston in accordance with
the type of caulking material container. Improper
piston may cause leakage or tool breakage.
• There are three types of rods. The rod for the
short holder (300ml(18.3cu.in)), rod for long
holder (600ml(36.6cu.in)), and rod for big holder
(800ml(48.8cu.in)). Use appropriate rod in
accordance with holder type.
• Always keep the rod and piston clean. Adhering
caulk may damage the tool.
Installing holder
Hold the bottom of the holder and the holder joint, then
turn the holder clockwise. Tighten it firmly until it stops.
Make sure the holder is tightened firmly. Otherwise the
tool may be damaged.
To remove the holder, turn it counter clockwise.
NOTE:
• You can rotate the holder in accordance with
required situations to facilitate the operation.
• The short holder (300ml(18.3cu.in)) and big
holder (800ml(48.8cu.in)) are intended for the
cartridges only. Use only piston A with short
holder (300ml(18.3cu.in)). Use only piston D
with big holder (800ml(48.8cu.in)) Do not use
them with film type packs or direct filling. Also
use appropriate rod in accordance with the
holder type.
Installing cartridge
NOTICE:
• Make sure the piston A is attached to the rod. Do
not use other type of piston for cartridge.
Installing the cartridge into the short
holder (300ml(18.3cu.in))
► 1. Rod handle
Pull the rod handle backwards slowly until it stops.
Insert the cartridge into the holder as illustrated.
Push the rod gently until the piston touches the bottom
of the cartridge.
To remove the cartridge, pull the rod backwards until it
stops, then lift out the cartridge.
8 ENGLISH
1