Pulsar APX eRig Manuel D'instructions

KIT INCLUDES
1x APX™ eRig main body with pivoting
detachable atomizer connection
1x Coil-less quartz cup atomizer
1x Removable airpath tube
1x Glass mouthpiece
1x Base jar
1x Downstem
1x Glass coil collar
1x Glass carb cap
TECHNICAL SPECIFICATIONS
Dimensions: 5.39x4.13x10.62 in (137x105x270mm)
Battery Capacity: 3200mAh
Charging: 5V/2.5A
Charging Time: 90 minutes
Temperature Settings: 482 to 842°F (250 to 450°C)
Heating Coil Resistance: 0.7Ω
Sesh Mode Time: 40 seconds after reaching set temperature
Auto Shut-Off: After 5 minutes of inactivity
HOW TO USE YOUR NEW DEVICE
1. Plug the APX ™ eRig into an appropriate wall charger using the provided cable. The light above the charging
port will flash red when the battery is between 0%-30%,
green when the battery is between 65%-100%. The light will turn solid
charged.
2. Once the unit is fully charged, it's time to assemble the device. Attach the mouthpiece to the main body by
gently pushing with a small twisting motion. Next, fill the base jar with water up to the fill line, then gently
push the downstem into the bottom of the main body. With the downstem in place, push the main body down
onto the base jar with a small twisting motion. Screw on the atomizer, being careful not to over tighten. Once
the atomizer is in place, press the glass collar on the atomizer connection. Finally, place the carb cap tether
on the collar and insert the top of the carb cap into the small hole at the end of the tether.
3. Click the power button 5 times to turn the APX eRig on or off. When you turn the eRig on, the light around
the power button will indicate the current temperature setting and the lower LED will flash
jar. When you turn the device off, the lower LED will flash white.
4. After the device is on, click the power button 3 times to change the temperature setting.
482°F (250°C) - Blue
572°F (300°C) - Cyan
662°F (350°C) - Green
752°F (400°C) - Purple
842°F (450°C) - Red
5. Once your preferred temperature is selected, load the atomizer with your concentrate. Be careful not to
overfill the atomizer. Once the atomizer is loaded, press and hold the power button to start heating. Release
the button to stop heating. During the heating process, the light around the power button will pulse and the
lower LED will cycle through multiple colors. The light around the power button and bottom LEDs will turn one
solid color when the temperature has been reached. Haptic feedback will let you know when your set
temperature has been reached and when the heating cycle has finished.
(Continued on next page)
PAGE 1
INSTRUCTION
MANUAL
1x Silicone carb cap tether
2x Quartz terp pearls (6mm diameter)
1x Terp Tong
1x Stainless steel dab tool
1x USB-C charging cord
2x Replacement O-rings
4x Alcohol swabs
1x Cleaning brush
1x Pulsar® silicone mat
yellow when the battery is between 30%-64%, and
green when the device is fully
green in the base
PU-0609-23
PU-0689-23