Publicité
6. Click the power button twice to start Sesh Mode. Click twice again to stop Sesh Mode heating. During the
heating process, the light around the power button will pulse and the lower LED will cycle multiple colors
while the device heats up. The light around the power button and lower LEDs will turn solid when the
temperature has been reached. Haptic feedback will let you know when your set temperature has been
reached and when the heating cycle has finished.
7. Once the device has finished its heating cycle it will enter standby mode for 5 minutes before powering off.
CHARGING YOUR DEVICE
100-65%: Green
64-30%: Yellow
30-0%: Red
Only charge using Pulsar® brand chargers and Pulsar brand accessories, as not all cables are manufactured the
same and we can't control for variation between electronics. To prolong the battery life and for your safety, only
use a charger with an output of 5V/2.5A or lower. The light above the charging port indicates battery level. When
the device is on, the battery level will be shown. When the device is off, press the power button one time to check
the battery level.
PULSAR® PRO TIPS!
Before you begin your sesh, grab the atomizer connection and pivot the APX™ eRig main body so the mouthpiece
is pointing towards you. This will keep you more comfortable during your session while keeping the atomizer in
the optimal position. The atomizer should stay in its vertical position so the oil distributes evenly across the entire
surface area of the coil.
TERP BEADS
Use one terp bead in the atomizer to enhace the quality of your session. The terp beads retain heat, so use
caution when removing the bead while the atomizer is still hot. We recommend waiting until the atomizer is cool to
the touch and using the provided terp tong to remove the bead.
PAGE 2
INSTRUCTION
MANUAL
Hold atomizer stable with
one hand and the
body/mouthpiece in the other
Use hand on the body
to pivot mouthpiece
toward the user
Atomizer remains
vertical
PU-0609-23
Publicité
