Télécharger Imprimer la page

Aquaglide WALK ON WATER Manuel Du Propriétaire page 7

Masquer les pouces Voir aussi pour WALK ON WATER:

Publicité

1. Locate a flat, dry area with access to outlet for electrical pump. The best setup position will also make launching
easy. Never drag product as damage may occur.
2. Unfold product completely and locate Main Valve [1]. To help future storage, closely note original folding & packaging
method. Remove valve cap and confirm valve is in inflate (1-way airflow) position.
3. Insert air pump hose with proper valve fitting into Main Valve [1], lock into place. Use pump to inflate Main Valve [1] to
Working Pressure as shown in Chart 1.
4. Repeat step 3 instructions to inflate each chamber to proper Working Pressure shown in Chart 1 until all chambers
are properly inflated.
5. Since this item will be attached to another, follow steps below to prepare connections prior to launching. When
connecting multiple items together follow guidelines carefully. Use only Two-Step Vario-lock straps and Aquaglide
connecting rings.
6. WALK ON WATER is a Boarding Feature item. Attach straps only where a connection is needed. Use all of the rings
required to make the connection, do not skip rings. Standard connections require 5 Vario straps and 5 rings on each
item. Attach straps to boarding feature before launching. Follow steps E1 - E2 below to attach the required straps.
A. Boarding features connect to, or between, main and track feature items. Boarding features should not be
attached to other boarding features (examples: Swimstep, Speedway, Splashmat, and Deck are other boarding
features).
B. With straps attached, float Boarding Feature into desired position where a matching set of connecting rings is
available on feature item.
C. Attach center strap to center ring on feature item. Connect loosely, leaving space to make all required
connections. Work outward until all straps are connected loosely.
D. Dive beneath to tighten all straps securely. Dive mask and several attempts may be required.
7. Confirm that suitable anchor(s) and mooring lines are in place before launching this item (see Anchoring).
8. To launch product, lift completely and place in water. Large items may require many extra people to accomplish this.
Never drag product as damage may occur.
9. When connecting multiple items together, always follow manufacturer's recommendations. Use only Aquaglide Two-
Step Vario-lock cinch straps and connecting rings. Make sure connection is tight and there is NO GAP between items.
Failure to connect items properly may result in injury or death. See E1 - E6.
7
Connecting Strap instructions
E-1
E-4
E-2
E-5
E-3
E-6
www.aquaglide.com

Publicité

loading