Witter RN72A Notice De Montage page 2

Fitting
Instructions
9. For the Renault Scenic Conquest remove bumper as per fitting instructions. For fitting carry out the same
procedure as per steps 3 to 7.
10. Replace all trim, plastic covers, bumper, reversing sensor connection, spare wheel, jack/polystyrene assembly,
and rear light clusters in reverse order.
11. To improve towball Bumper clearance, 10 mm packers are required to be added to the Part A face plate, with a
maximum allowance of 20 mm. Longer M16 x 2.00 mm Pitch bolts will also be required depending on packers
used.
Renault Conquest Bumper cut
30
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
W0001RN72A-FIT$010802220000ÎÄ
W0001RN72A-FIT$010802220000
Additional instructions
for Renault Scenic Conquest 2008 –
RN72