Treating With Silk'n Clear For The First Time - Home Skinovations Silk'n clear UE08WCP-105040SPA Notice D'utilisation

Treating with Silk'n Clear for the First Time

The skin should be, clean, dry and free of any powder, gel or cream.
Remove Silk'n Clear Applicator from its cradle in the Base Unit.
Press the Power On/Off Switch. The green Ready/Treatment
Indicator Light (I) will start blinking, and shortly afterwards will
be lit steadily.
Your Clear is ready for treatment.
Place the Treatment Surface on your skin. The Led light will
automatically activate.
Keep holding the Clear Applicator against the skin area for 3-4
minutes. The Treatment Surface temperature will slowly increase.
Move the Treatment Surface to the next location and hold
against the skin for another 3-4 minutes.
Perform the treatment for 3-4 minutes on each infected area.
Throughout the treatment course and maintenance period, it
is recommended to wash the infected areas daily, using Silk'n
Acne™ soap.
Apply Silk'n Acne™ soap on a wet skin and lather gently,
leave for 30sec., wash and tap softly
using a clean towel to dry.
11