Ooni Karu 2 Pro Mode D'emploi page 10

Problem
My oven isn't getting hot enough
My gas burner will not ignite
My flame is too yellow / too blue
My oven switches off after I let go
of the control dial.
Gas Burner for Karu 2 Pro
will not maintain its flame
I can hear a 'roaring sound' coming
from the Gas Burner and my
flames are very weak
The flame coming from my gas
burner seems too powerful
If problems persist, please contact Ooni support
8
Possible cause
1. Empty gas bottle
2. Gas leak in the hose
3. Regulator improperly fixed
4. Operation in extreme conditions
5. Gas bottle is too small
6. Oven is not set up correctly
7. Gas burner is backlighting (typically
accompanied by a roaring sound)
8. The pizza stone is wet
1. Improper set-up
2. Empty gas bottle
3. Cracking or leaking from the hose
4. Improper lighting technique
5. Regulator improperly fixed
6. Improper alignment of the sparker
Variation in the environment, the food
you cook, ambient temperature and
condition of your Ooni oven may effect
the colour of your flame
There may be soot build up on the
FSD probe
1. Lack of oxygen
2. Oven placed on an uneven surface
3. Your gas burner should not be used
in extreme conditions (eg high winds)
Gas Burner is backlighting so the flame
is in the venturis
Gas bottle is not being used in the
correct orientation
Prevention / Solution
1. Check the gas bottle is full; an empty or
even a nearly empty bottle may affect gas
burner performance.
2. Perform a leak test and ensure there are no
cracks or leaks in the hose.
3. Ensure the regulator is properly fixed
to the gas bottle and the hose is firmly
attached to the gas burner.
4 Your gas burner and oven should not be
used in extreme conditions (eg high wind)
5. Select a gas bottle with a power rating
suitable for the gas burner.
6. Check the oven is set up according to the
instructions in this manual.
7. Follow the steps to turn off the gas burner
and re-ignite the oven.
8. Extend the preheat time to allow excess
moisture to evaporate and the stone to
dry out. To prevent this in future, use
the chimney cap, store indoors or use a
waterproof cover.
1. Check the oven is set up according to the
instructions in this manual.
2. Check the gas bottle is full, an empty or
even a nearly empty bottle may affect gas
burner performance.
3. Perform a leak test and ensure there are no
cracks or leaks in the hose.
4. Turning the dial too quickly may prevent
the gas burner from lighting.
5. Ensure the regulator is properly fixed
to the gas bottle and the hose is firmly
attached to the gas burner and tightened
using appropriate- sized wrenches as
outlined in the instruction manual.
6. Reposition the sparker tip so it is 3 mm
away from the front of the burner cap.
The color of your flame will not affect the
taste or quality of your food.
Ensure the gas burner and gas supply are
switched off. Wait for the burner to cool down.
Gently clean the probe and burner holes with
a damp cloth. Leave the burner to dry fully
before re-lighting.
1. Check the oven is set up according to the
instructions in this manual.
2. If your Ooni is on a slant when set up, the
oxygen will not flow as well. Try to set your
oven up on a flat surface.
Switch off the gas supply and the gas burner
immediately, wait five minutes and relight the
gas burner.
Ensure the gas bottle is positioned upright