Télécharger Imprimer la page

CANGAROO ROTEX 360 Notice D'utilisation page 10

Publicité

shown in section PD. The car seat base is developed for an intensive use of
approximately 6 years.
IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
WARNING!
Warning! Do not use any load bearing contact points other than those
described in the user guide and marked on the car seat.
Install the car seat base only on a forward-facing vehicle seat.
Never install the car seat in forward facing position onto the base in the car.
Do not use on a passenger seat with front airbag.
For maximum protection, the safest position in most cars the central position
on the rear seat is recommended.
Always protect your child when it is in the car seat using the safety belt.
Make sure that all belts attaching the restraint system to the vehicle are as
tight as possible. Make sure that the belts that secure the child are adjusted
to fit the child's body, tightened as much as possible without causing
discomfort to your child and are not twisted.
Do not use other load bearing points, except for those described in the
instructions and indicated on the car seat and base.
Make sure that all rigid elements and plastic parts are safe. System is properly
locked and there is no danger in daily use of the stool in the adjustable seats
and the doors of the vehicle are trapped.
Do not make any changes, improvements and do not add new accessories or
pads on the car seat base except for those approved by the manufacturer and
without prior proof of an authorized organization. Please, make sure that you
follow carefully the instructions of the manufacturer, when you place and
adjust this restraint system.
Keep out of fire !
Dо not store the product in humid places and in direct sunlight.
IMPORTANT! The diagrams and figures in this instruction are illustrative and indicative
only.
MAIN PARTS OF THE CAR SEAT BASE: 1. Support leg; 2. Car seat release button; 3. Car
seat fastening brackets; 4. Base; 5. ISOFIX connectors; 6. ISOFIX release buttons; 7.
Support leg extention part; 8. Adjustment button for the support leg.
CHILD SEAT INSTALLATION WITH ISOFIX BASE - FIGURE E
ASSEMBLY AND EXPLOITATION
CHILD'S HEIGHT: 40-87 cm
10

Publicité

loading

Ce manuel est également adapté pour:

Wg10