Télécharger Imprimer la page

Axis P13-B Serie Guide D'installation page 3

Masquer les pouces Voir aussi pour P13-B Serie:

Publicité

Low Voltage Directive (LVD) 2014/35/EU. See
Safety, on page 4.
Restriction of Hazardous Substances (RoHS)
Directive 2011/65/EU and 2015/863, including
any amendments, updates or replacements. See
Disposal and recycling, on page 4.
A copy of the original declaration of conformity may
be obtained from Axis Communications AB. See
Contact information, on page 6.
Electromagnetic compatibility (EMC)
This equipment has been designed and tested to fulfill
applicable standards for:
Radio frequency emission when installed
according to the instructions and used in its
intended environment.
Immunity to electrical and electromagnetic
phenomena when installed according to the
instructions and used in its intended environment.
USA
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference,
and
2.
this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested using an unshielded
network cable (UTP) and found to comply with the
limits for a Class A digital device, pursuant to part 15
of the FCC rules. This equipment has also been tested
using a shielded network cable (STP) and found to
comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against
harmful interference when the equipment is operated
in a commercial environment. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance
with the instruction manual, may cause harmful
interference to radio communications. Operation of
this equipment in a residential area is likely to cause
harmful interference in which case the user will be
required to correct the interference at his own
expense.
Contact information
Axis Communications Inc.
300 Apollo Drive
Chelmsford, MA 01824
United States of America
Tel: +1 978 614 2000
Canada
This digital apparatus complies with CAN ICES-3
(Class A). The product shall be connected using a
shielded network cable (STP) that is properly grounded.
Cet appareil numérique est conforme à la norme
CAN NMB-3 (classe A). Le produit doit être connecté à
l'aide d'un câble réseau blindé (STP) qui est
correctement mis à la terre.
Europe
This digital equipment fulfills the requirements for RF
emission according to the Class A limit of EN 55032.
The product shall be connected using a shielded
network cable (STP) that is properly grounded. Notice!
This is a Class A product. In a domestic environment
this product may cause RF interference, in which case
the user may be required to take adequate measures.
Australia/New Zealand
This digital equipment fulfills the requirements for RF
emission according to the Class A limit of
AS/NZS CISPR 32. The product shall be connected
using a shielded network cable (STP) that is properly
grounded. Notice! This is a Class A product. In a
domestic environment this product may cause RF
interference, in which case the user may be required to
take adequate measures.
Japan
この装置は、クラスA機器です。この装置を住
宅環境で使用すると電波妨害を引き起こすこと
があります。この場合には使用者が適切な対策
を講ずるよう要求されることがあります。 VCCI
‒ A
本製品は、シールドネットワークケーブル(STP)
を使用して接続してください。また適切に接地
してください。
本製品は電気通信事業者(移動通信会社、固定
通信会社、インターネットプロバイダ等)の通
3

Publicité

loading

Ce manuel est également adapté pour:

P1385-bP1387-bP1388-b