Table des Matières
Publicité
1. Safety Instructions
•
Please keep this User Manual for future reference. If you sell the unit to another user, be sure that he also receives
this instruction booklet.
•
Unpack and check the unit carefully that it has not been damaged during transport before using the unit.
•
Before operating, ensure that the voltage and frequency of power supply match the power requirements of the unit.
•
It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
•
The unit is for indoor use only in a dry location.
•
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces. Be sure that
no ventilation slots are blocked.
•
Disconnect mains power before fuse replacement or servicing.
•
Replace fuse only with the same type.
•
Make sure there are no inflammable materials close to the unit during operation.
•
Use safety cable when fixing this unit.
•
In the event of serious operating problem, stop using the unit immediately.
•
Never try to repair the unit by yourself. Repair carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center and always use the same type of spare parts.
•
Do not touch any wires during operation as high voltage might be causing electric shock.
2. Specifications
Supply Voltage: .............................................................................................AC220～240V 50/60HZ
Power: ........................................................................................................................................ 10W
LED: .............................................................................................................. White 8 mm LED 50pcs
Function: ......................................................................... sound active mode with sensitivity control
Dimensions: ............................................................................................................. 200x170x140mm
Weight: ...................................................................................................................................... 500g
3. Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid
vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit is secure and
is able to support a weight of 10 times of the unit's weight. Also always use a safety cable that can hold 12 times of the
weight of the unit when installing the fixture.
The equipment must be fixed by professionals. It must be fixed at a place where is out of the reach of people and nobody
can pass by or under it.
4. Operation
Connect the unit to an appropriate mains outlet. Switch the unit on via the ON/OFF switch. Turn the sensitivity control of
the built-in microphone to the desired level. The unit will flash to the sound of the music.
5. Fixture Cleaning
The cleaning of the lenses must be carried out periodically to optimize light output. Cleaning frequency depends on the
environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation
of dirt on the unit's optics.
•
Clean with soft cloth using normal glass cleaning fluid.
•
Always dry the parts carefully.
•
Clean the external optics at least every 20 days.
©Copyright LOTRONIC 2012
GB
NIGHT+LIGHT
Page 2
Publicité
Table des Matières
