Publicité
A
3. OPERATION
3.1 OSD
1
Auto/Exit
2 Menu/Select
3 "+"/Brightness
4 "-"/ECO
5 Power
3.1 Auto/Exit key
Under OSD menu,this key is used for exiting the OSD.
If not under OSD menu, this key helps players to find the shooting point.
3.2 Menu key
This key is used for entering into main menu and confirming your selecting.
3.3 "+"/Brightness
Under OSD menu, this key is used to go up in the menus.
3.4 "-"/ECO
Under OSD menu, this key is used to go down in the menus. If not under OSD
menu, this key is for ECO adjustment.
3.5 Power on
This key is used for turning on or turning off the power supply.
OSD menu
1.1 Main menu
Item: 1. Picture adjusting 2. Color adjusting 3. Size position 4. Set up
5. Information
1.2 Submenu
ltem: 1. Brightness 2. Contrast 3. Color Temp 4. Red 5. Green 6. Blue
7. Aspect Ratio 8. Bluelight Fitter 9. Language 10. Signal source
11. Menu H position 12 .Menu V position 13. Menu Timer 14. Volume 15. Reset
10
3.2 Safeguard
When the video signal of your computer exceeds the frequency range of
monitor (refer to product specification),the micro-computer of monitor will
turn off the sync signal of horizontal and vertical for the purpose of monitor
protection,please refer to the illustration below.The monitor will enter saving
mode after few seconds, and the power indicator will light red.Please
set the output frequency of your computer
within the acceptable range of monitor
so that the monitor can work normally.
A
11
Publicité
