Publicité
English | 10
Setting
1) After mounting the SN130 sensor, press the ON button. The relay will turn ON
and the
LED will light up
turn OFF.
2) Set the desired humidity value using the rotating wheel.
a value of 20 to 95% relative humidity (RH). When this value is exceeded, the
output relay is switched on and the
3) The optimal RH
The sensor has a fi xed hysteresis of 5% RH.
BOOST mode (load switching for 10 min):
1) To activate, press the ON button. The relay will turn ON, the
up and the sensor will countdown 10 minutes.
2) To deactivate the function, press the ON button again.
A
5
setting for a household is between 40-60%.
relay switching indication - load is switched on for 10 minutes
(BOOST mode)
load is switched off
relay switching indication - humidity has exceeded the set value
. Press the button ON again and the relay will
LED lights up
Indication LED
. It is possible to set
B
.
A
LED
A
will light
Publicité
