Hansa styro Horizon Mode D'emploi

Horizon
Installation wall
Operation
Touch switch to turn on / off the lamp
Double Dimming mode:
• Short touch to adjust brightness (3 steps)
• Long touch for stepless brightness
adjustment (10 % – 100 %)
Colour temperature change in 3 steps:
3800, 2800, 5700 K
Memory function: previous colour temp.
and dimming level are recalled at following
turn on
styro ag
Frauholzstr. 27, CH-6422 Steinen
Tel. +41 (0)41 833 80 10
info@styro.ch | www.styro.ch
EU Distributor | styro GmbH
Industriestr. 2, D-91583 Schillingsfürst
Tel. +49 9868 98949-0
verkauf@styro.de | www.styro.de
Power adapter
DC plug
1
Installation base
1
(1) Position the lampbody on the base and
(2) clip it on the base
(1) Glue using the adhesive
tape or screw the wall accessory,
position the lampbody on it and
(2) clip it on the wall accessory
2
Lamp adjustments
Control panel
Technical data
Voltage:
Lighting power:
Luminous flux:
Colour temp.:
Protection class:
Ingress protection: IP20
Model number:
This product contains a light source of
energy efficiency class F
The construction of the luminaire does not
allow the lighting source to be replaced,
as there is a risk of damaging the luminaire.
The operating device is in the adapter.
2
100°
Fexible goose neck
SP20240708
AC 220-240 V, 50-60 Hz
9 W
530 lm
2800, 3800, 5700 K
II (w/o adapter III)
41-5011.126 / 127