Basic Operation - Teac DS-H01 Mode D'emploi

Basic Operation

1
Press the power button (STANDBY/ON) to turn
the power on.
o If nothing is connected to this unit when the power
is turned on, it will enter standby mode, and the ring
around the button (power indicator) will not light blue .
When you connect an iPod/iPhone/iPad to the dock
connector or connect an operating computer to the
unit using a USB cable, the power indicator will light
blue .
o When connected to an amplifier, always turn
the amplifier's power on very last to avoid
sudden loud noises .
2
After turning the iPod/iPhone/iPad power on,
connect it to the dock.
For details about how to connect an iPod/iPhone/iPad,
see "Using an iPod/iPhone/iPad with the Dock" on
page 9 .
o If you connect an unpowered iPod/iPhone/iPad to the
dock, it might not operate correctly after its power is
turned on .
o The iPod/iPhone/iPad in this unit's dock will be
charged whenever this unit's power plug is connected
to a power source and its power is turned on .
o With some iPod/iPhone/iPad models, no sound will be
output from headphones that are plugged into them
when the device is connected to the dock .
o You can output the iPod/iPhone/iPad video signal
from this unit's video output jacks (VIDEO OUT) to a TV
or display . (See page 7
o When outputting iPod/iPhone/iPad video from a
video output jack to a TV or other display, connect the
iPod/iPhone/iPad to this unit's dock before starting
playback .
o When using an iOS application on an iPod touch,
iPhone or iPad, start the iOS application before
connecting the device to the dock .
o If a case being used with an iPod touch, iPhone or iPad
touches this unit's dock when the device is connected,
remove the case and reconnect it .
12
C
and page 14 . )