Télécharger Imprimer la page

Battery Connection - XciteRC Battery Check + Balancer Mode D'emploi

Publicité

Les langues disponibles

Les langues disponibles

Battery Connection · Parameter settings

Battery Connection

Servo
jack
S
Rotary
adjuster
Servo
EH and XH type plug on lithium battery packs can be directly connected to the 9-pin connector of the Bat-
teryCheck. The negative pole is always at the top.
NiMH / NiCd batteries are plugged into the upper socket, the negative pole is at the top. Both sockets can
be used simultaneously, the battery to be tested can be selected via the TYPE button.
If a LiXX battery is to be measured with only one cell - or NiXX batteries under 4 cells, a separate voltage
supply with min. 5 V DC must be connected at the other input.
Overview Parameter Settings
To program the following parameters, press and hold for TYPE key min. 1 sec. to enter the programming
mode. Press TYPE briefly to select the next parameter. The values are increased with MODE, reduced with
CELL. Long press MODE or CELL to change values faster. Press and hold the TYPE button again min. 1
sec. to return to the voltage display.
Press
Discharge-
Voltage
cut-off-
display
TYPE
voltage
Press
TYPE
Voltage display
Set Servotest range
Range: 500 - 2500us,
1000 - 2000us
#52300000 Battery check + balancer
Press
Servotest
frequency
TYPE
Voltage
display
Set discharge cut-off voltage
Range: 2 - 4.35 V
LCD backlight duration
off, 10 - 60 sec., on
NiXX (4-8 cells)
LiXX (2-8 S)
Press
Press
Servotest
signal range
TYPE
TYPE
Range:
Press
LCD
Signal tone
backlight
TYPE
Press
TYPE
Set Servotest frequency
Range: 50, 60, 100, 125
200, 250, 300 Hz
Signal tones ON/OFF
Range: OFF/ON
EN
5

Publicité

loading

Ce manuel est également adapté pour:

52300000