Setting The Alarm - Sangean PR-D3 Mode D'emploi

Clock time setting
After the batteries are installed or AC power is plugged in, the
screen will display all icons, then the display will show -:--.
. Clock time can be set while radio is on or off.
2. Press and hold the Clock set button, the hour digits will flash,
press the Tuning Up/Down (or use the Tuning control rotary) to
adjust the required hour time.
3. Press and release the Clock set button again, the minute digits
will flash, press Tuning Up/Down button again to adjust the
required minute time.
4. Press and release the Clock Set button again to complete time
setting. This also sets the seconds to "00."

Setting the alarm

Setting the type of alarm
There are two different alarm modes in this unit. You can choose to
wake up to the radio (
can set the alarm with the radio on or off.
. Press and hold the Alarm button until you hear a beep and see
one of these symbol
2. Now both the hour digit and alarm symbol will flash. Press the
Tuning up/down button to set the required hour. Then press the
Alarm button again.
) or to a buzzer (
or flashing on the display.
GB
). You
9