Publicité
4.
Select "Use QR code".
5.
Scan the pump QR code, which is located on the cover of the remote control.
6.
Press
and
to enable Wi-Fi on the pump. "BLE" will be displayed on the screen.
MODE
SET
MODE
SET
7.
Press "Next".
8.
Pair the pump to your phone when asked to do so.
9.
Press and hold
for a few seconds.
10. Set up the Wi-Fi for connection to the pump. Select "Wi-Fi" and enter the Wi-Fi password.
MODE
SET
11. Pump already paired. The pump will appear in "Equipment" ready for direct control from APP.
12. When the pump is connected to the APP, the display will show all the data as in MANUAL mode,
but with the WIFI symbol activated on the screen.
13. When the pump speed is changed, the pump display will show the new speed selected from the APP.
14. If the speed is changed from the UI on the main screen, the speed of the pump will be updated in
the APP.
15. If AUTO mode is selected in the app, AUTO will be displayed on the pump screen. When an AUTO mode time
setting is activated, the information will appear on the display (100, current time, APPt, C1)
16. If the pump is switched off locally, it will also be switched off in the APP and the mode will be changed to
OFF. If ON is selected again in the APP, it will appear in the previous mode: in this case, AUTO.
17. If the AUTO mode is changed to MANUAL mode, the mode will also be changed to MANUAL in the app.
•
Restore
1. Press
to enter Settings menu.
MODE
SET
2. Press
or
until "rSET" displays.
MODE
SET
3. Press
to restore to the factory defaults. Display will turn Off.
MODE
MODE
SET
SET
Factory Defaults
•
Low Speed: 50%
•
Medium Speed: 75%
•
High Speed: 100%
•
Priming Speed: 100%
•
Priming Time: 1 minute
•
Speed in MANUAL Mode: Low speed
•
AUTO/Schedule: OFF
•
Schedule Settings: All speeds are LOW; T-Start and T-Stop are "00:00"
•
APPt: Disabled
•
Wi-Fi-Bluetooth: OFF
Installation and general maintenance manual
- VARIABLE SPEED PUMP CALITA 2 VS
17
Publicité
