Installation Location; Changing Over The Door Hinges; Aligning The Appliance - Siemens KD N Série Mode D'emploi

en
ã=
Warning
Never connect the appliance
to electronic energy saver plugs.
Our appliances can be used with mains
and sine-controlled inverters. Mains-
controlled inverters are used
for photovoltaic systems which
are connected directly to the national
grid. Sine-controlled inverters must be
used for isolated applications (e.g. on
ships or in mountain lodges) which are
not connected directly to the national
grid.

Installation location

Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e. g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use
a suitable insulating plate or observe
the following minimum distances to a
heat source:
3 cm to electric or gas cookers.
■
30 cm to an oil or coal-fired cooker.
■
Appliances with fitted handles
must be situated at least 55 mm
from the wall on the hinge side so
that the door can be opened by 90°.
Changing over
the door hinges
We recommend that you have the door
hinges changed over by our customer
service.
Before changing over the hinges, pull out
the mains plug or disconnect the fuse.
24
ã=
Caution
Carefully place the appliance on its back.
Installation in numerical sequence.
1. Changing the door handle. Fig. */B

2. Changing over the door hinges.

Fig. */A

Aligning the appliance

Place the appliance in the designated
location and align. The appliance must
be level. If the floor is uneven, use
the front height-adjustable feet. Adjust
the height-adjustable feet with a wrench.
Note
The appliance must be upright. Please
align it with a spirit level.