Simons Voss Technologies SmartHandle AX Advanced Reader on both sides Guide Abrégé page 33

SmartHandle AX Advanced Reader on both sides
ü Drill at hand.
Suitable drill bit at hand (Ø 7 mm).
ü
Countersink at hand.
ü
1. Insert the spindle into the mortise lock.
2
2. Place the drilling template on the spindle from the inner side.
3
3. Mark the points to be drilled on the inner side of the door.
4
5
4. Remove the drilling template.
6
5. Place the drilling template onto the square from the outside.
7
6. Align the drill template vertically using the printed scale.
7. Mark the points where the door is to be drilled on the door.
8
9
8. Remove the drilling template and spindle.
10
9. Remove the mortise lock.
11
10. Drill the required holes.
12
13
11. Deburr drilled holes with a countersink.
14
12. Fit the mortise lock.
15
5. For door thickness X: prepare the
spindle
ü Caliper gauge at hand.
ü Saw at hand.
1. Measure the door thickness.
16
2. For X: mark the sawing point on the spindle.
17
3. For X: Trim the spindle with a suitable saw.
18
6. Installing the fitting
Door pre-drilled.
ü
Blind rivet nut pliers at hand.
ü
ü PH2 screwdriver at hand.
ü TX15 screwdriver at hand.
1. Fit the blind rivet nuts into the pre-drilled holes.
19
20
2. For non-MO: insert the blank cylinder.
EN
5. For door thickness X: prepare the spindle
NOTE
Feed the blank cylinder into the hole using a screwdriver
It is difficult to position the blank cylinder correctly, especially in thick doors.
1. Insert a screwdriver into the hole in the blank cylinder.
2. Position the blank cylinder using the screwdriver.
21
22
3. For non-MO: screw the blank cylinder firmly into position.
23
4. Use the 12 mm screws to fix the outer fastening plate onto the outer
side of the door (PH2) with the tip facing upwards.
You can identify the outer fastening plate by its elongated holes.
24
25
26
5. For 7 mm spindle: Insert the adapter shoe into the spindle mount on the
module support.
27
6. Insert the module support into the fastening plate.
28
7. Slide the module support upwards.
29
9 Module support snaps into place.
8. Use the 18 mm screws to fix the module support onto the fastening
plate (PH2).
30
31
9. Place a cover on the fastening plate at the top.
32
10. Fold down the cover.
33
11. Push the cover against the door, sliding it upwards at the same time.
34
9 Cover snaps into place.
12. Press the inlay into place.
35
13. Fit the outside handle.
36
14. Tighten the grub screw in the outer handle.
37
15. For 8.5 mm, 9 mm and 10 mm spindle: slide the adapter sleeve into the
centre of the spindle. Use a punch and hammer to make an indent in the
adapter sleeve to prevent it from slipping.
38
39
16. Insert the spindle into the door as far as it will go.
40
17. Use the 12 mm screws to mount the inner fastening plate onto the inner
side of the door (PH2) with the tip facing upwards.
24
42
43
33 / 56