Publicité
Disassembly & Assembly of the Plush Cover
①
1. Unzip the bottom zipper, pull open
four Velcros, and remove the bottom
plush cover.
2. Remove the plush, unscrew the
screws at A and B point with a
screwdriver, and pull out the handle
sleeve.
③
3. Hold the handle sleeve at the other
end, pull out the handle bar tube, and
finally remove the plush cover.
4. Reverse the above steps, the plush cover installation can
be completed.
10
Put the plush cover into the
car body, zip up the bottom
zipper, fasten four Velcros
in the direction of the arrow,
and the installation is
complete.
②
A
B
Battery Installation
①
1. Unzip the bottom, unscrew the screws
with a screwdriver, and open the battery
cover.
2. Switch on the positive and
negative terminals of the power
supply and put the battery into the
battery compartment.
③
3. Close the battery cover, tighten the
screws, zip up, and complete the
installation.
Black
Connector
Red
Terminal
When connecting the connectors to the storage battery make sure
they are connected in correct polarity.
②
Red Wire
Black
Wire
Battery
Black
Terminal
Red
Connector
11
Publicité
