Uline H-9013 Mode D'emploi

H-9013
PEGBOARD CART
WITH SHELVES
TOOLS NEEDED
8 mm Combination Wrench
10 mm Combination Wrench
12 mm Combination Wrench
14 mm Combination Wrench
• Do not sit, climb, hang or step on hooks or holders.
• Do not overload hooks or holders.
Deck x 1
8" Deep Shelf x 1
Long Bolt x 16 Short Bolt x 34
PAGE 1 OF 9
1-800-295-5510
uline.com
or
8 mm Socket Wrench
10 mm Socket Wrench
12 mm Socket Wrench
14 mm Socket Wrench
Support Frame x 2
10" Deep Shelf x 1
Washer x 16 M5 Flange Nut x 8
M6 Flange Nut x 34
M8 Flange Nut x 16
Figure 1
#2 Phillips Screwdriver
Two Person Assembly
Required
SAFETY
• Do not try to assemble pegboard cart by yourself.
Use two people.
PARTS
Pegboard Panel x 2
12" Deep Shelf x 1
Phillips Head Bolt x 8
ASSEMBLY
ATTACH SUPPORT PANELS
1. Position deck on flat surface with lipped edge facing up.
Place one support panel against the inside corner of the short
side of the deck. Align holes on the bottom of the support
panel with holes in the deck lip. (See Figure 1)
2. Insert three short bolts through the holes in the deck lip.
Thread on M6 flange nuts and secure using 10 mm wrench,
but do not tighten. (See Figure 1)
3. Repeat steps 1 and 2 for second support panel.
(See Figure 1)
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7- 9.
Top Bar x 1
Handle x 2
Rigid Caster x 2 Swivel Caster
with Brake x 2
1120 IH-9013