VEVOR LH40 Mode D'emploi page 5

2. Type Y attachment: If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
3. In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this
appliance must not be supplied through an external switching device, such as a timer, or
connected to a circuit that is regularly switched on and off by the utility.
4. In the process of temperature adjustment, there will be a slight delay in the digital display
temperature, which is a normal phenomenon, please wait a moment.
SAVE THESE INSTRUCTIONS
Instruction Manual of LH40 Pyrograph Machine
1) Pyrograph machine switch: Turn on the switch when using it, and turn it
off when not in use to avoid danger.
2)Thermostat: It is used to adjust the temperature of the pyrograph pen.
The light gray part is the normal adjust ment of the rendering tempera ture,
and the red part is the high temperature area. The temperature adjustment
of the electrical heating wire pen is to slowly adjust the temperature
through the temperature regu-lator. If it is temperature display,adjust the
temperature to 700 degrees and then slowly lower it,it would be best the
- 4 -