Temperature Regulation - Candy Cwc033M Manuel D'utilisation

EN
1. Before rst use
Remove all packaging materials. This includes the foam base and all adhesive tape
holding the wine cellar accessories inside and outside. Keep them out of children's
reach and dispose them in an environmentally friendly manner.
Clean the inside and outside of the appliance with water and a mild detergent before
putting any wine in it.
After the appliance has been levelled and cleaned, wait for at least 2 hours before
connecting it to the power supply. If your wine cellar has been tilted for any reason,
wait 24 hours before plugging it in. See section INSTALLATION.
Once you have plugged the unit into an electrical outlet, let the unit run for at least
30 minutes to acclimatize itself before making any adjustments.
The temperature is automatically set to "4 "gear . If desired, you can change the te-
mperature manually. Please see TEMPERATURE.
2. Lamp switch
This product is equipped with a light switch on the right side of the thermostat box to
control the lighting on the product.
Lamp switch
The "-" of the light switch represents on ，"O"represents disconnection，
Please pay attention to the switch status before use.

3. Temperature regulation

·The temperature range of the wine cabinet: 6-15 ℃, suitable for storing various types
of wine.
·The temperature of the wine cabinet is adjusted through the temperature control knob.
'1,2,3,4,5,6,7' represents the specific gear position of the temperature controller and
does not represent the specific temperature.
·Normally, 1-2 gears are in high temperature,3-5 gears are in the middle range, 6-7 gears
are low.
·The factory gear of the wine cabinet is "4".
·The temperature inside the wine cabinet changes with the ambient temperature and
temperature controller gear.
Temperature control knob
19