LUND REVOLUTION Mode D'emploi

PARTS LIST:
Qty Description
1 Bull Bar
1 Driver/Left Frame Mounting Bracket
1 Passenger/Right Frame Mounting Bracket
1 LED Light Bar
4 10-1.5mm x 35mm Hex Bolts
EQUIPMENT NEEDED:
Safety Glasses
•
Ratchet Set
•
Pliers or Adjustable Wrench
•
IMPORTANT NOTES:
Bull Bar may interfere with parking sensors on the bumper.
•
The LED light bar can be wired into the factory lighting.
•
If state law requires a front license plate, a relocation kit is available separately.
•
For cleaning, mild soap may be used to clean the Bull Bar, and aluminum polish may be used on the
•
stainless steel to polish small scratches and scuffs on the finish.
REMOVE CONTENTS FROM BOX, VERIFY ALL PARTS ARE PRESENT, & READ INSTRUCTIONS
•
CAREFULLY. NOTE: PROFESSIONAL INSTALLATION IS RECOMMENDED.
Passenger/Right Side
Frame Mounting Bracket
Page 1 of 4
Qty Description
8 10mm x 27mm OD x 3mm Flat Washers
4 10mm Lock Washers
4 10-1.5mm Hex Nuts
1 Wiring Harness
4 Bolt Assembly
Driver/Left Side Frame
Mounting Bracket
I-Sheet Number I-20256 Rev.A
REVOLUTION BULL BAR
2010-17 DODGE RAM 25-3500
01/24/17