VEVOR FT-04 Mode D'emploi page 4

11. Do not use the ladder for two or more people at the same time;
12. Minors should only use ladders under the guidance of their guardians;
13. When using a ladder, climb up or down slowly to avoid personal injury
or accidents caused by falling or bumping the ladder;
14. Before using a ladder after placing it for a long time, check whether the
ladder is loose to prevent personal injury or accidents;
15. Before installing the ladder, ensure that the dock mounting plate is solid
and ready for use;
16. To avoid personal injury, do not install a ladder if the dock mounting
plate is rotten;
Positioning and Erecting the Ladder
1. Ladder shall be erected at the correct position, such as the correct angle
for a leaning ladder;
2.Ladder shall be on an even, level and unmoveable base;
3.Leaning ladder should lean against a flat nonfragile surface and should
be secured before use, e.g. tied or use of a suitable stability device;
4.When positioning the ladder, consider the risk of collision with the ladder
e.g. from pedestrians, vehicles or doors. Secure doors (not fire exits)
and windows where possible in the work area;
5.Identify any electrical risks in the work area, such as overhead lines or
other exposed electrical equipment;
6.Ladder shall be stood on its feet, not the rungs or steps;
7.Ladders shall not be positioned on slippery surfaces (such as ice, shiny
surfaces or significantly contaminated solid surfaces) unless additional
effective measures are taken to prevent the ladder slipping or ensuring
contaminated surfaces are sufficiently clean.
Using the Ladder
1.Do not exceed the maximum total load for the type of ladder;
2.Do not overreach; user should keep their belt buckle (navel) inside the
stiles and both feet on the same step/rung throughout the task;
3.Ladders should only be used for light work of short duration;
4.Use non-conductive ladders for unavoidable live electrical work;
- 3 -